|M2xP0.25 (fine thread) xL1.5 Round nut
Round nuts are to produce parts according to customer's drawings. If there is not formal drawing, then the sketch is OK too. Based on the sketching, we will make the formal drawing. And we requires approval from you about the formal drawings.
The round nuts was chasing process to take the chamfer on the back side. For chasing processing, the concentricity between the material outer diameter and the screw can be guaranteed within 0.02 mm. Also, the perpendicularity between the end face and the screw is the same. In the diagrams shown here, M2 has fine thread 0.25, but coarse thread 0.4 can be produced too. Also, it is possible to produce M1, M1.2, M1.4, M1.6, M1.7, M1.8, M2, M2.3, M2.5, M2.6 and M3. We ara possible to produce coarse thread and fine thread.
Our specialty materials are brass and outside diameters are 5mm or less.