Custom-ordered Small Set Screws

Set Screws M2xP0.25xL1.0
Material is Stainless Steel
(tyu)setscrew(M1x0.8)(zu).JPG (tyu)setscrew(M1x0.8).JPG

 

Set Screws M2.6xP0.45xL4.5
Material is Stainless Steel
(tyu)setscrew with dog point(zu).jpg (tyu)setscrew with dog point.jpg

 

Set Screws M2xP0.4xL2.5
Material is Aluminum
(tyu)M2x2.5(Al)(zu).jpg (tyu)M2x2.5(Al).jpg

 

Set Screws M2xP0.25xL4.0
Material is Brass
(tyu)protector-adjust-screw(zu).JPG (tyu)protector-adjust-screw.JPG

 

Set Screws M1xP0.25xL5.7
Material is Brass
(tyu)pin-neji-M1x5.7(zu).JPG (tyu)pin-neji-M1x5.7.JPG

This section describes about a custom-ordered setscrews.

This section describes about a custom-ordered setscrews.

  •   Specialty Setscrews in us
  1. In driven recess for the screws, we can manufacture the minus slot only.
    We can not manufacture a cross recess, a hexagon socket and a square socket.
  2. In the setscrews length, those are equal case to a diameter, or those are shorter case than a diameter, we are good at manufacturing.
  3. In nominal diameter, we are good at manufacturing of the setscrews which is less than or equal to M2.
  4. In materials, we are good at manufacturing of setscrews which are nonferrous metals or free-cutting steel.
  5. In screw pitch, we are good at manufacturing also the fine screw thread.
  • Weak Setscrews in us
  1. In the length, we are not good at manufacturing of setscrew length of more than about 3 times of the diameter.
  2. In nominal diameter, we are not good at manufacturing of the M4 or more setscrews.
  3. In materials, we are not good at manufacturing of the stainless steel setscrews or the tool steel setscrews.

Nominal diameters of standard setscrews are M1, M1.2, M1.4, M1.6, M1.7, M2, M2.3, and M2.5.

But, we can also manufacture the nominal diameters not listed above.

However, there is a limit of manufacture by the materials and the screw pitches.

These have limits, because the rigidity of our microcomputer control cam-type automatic lathes is low.

For example, the coarse screw thread is below.

  • If the material is brass, we can manufacture nominal diameter M4 or less, and pitch is 0.7 or less.
  • If the material is free-cutting steel, we can manufacture nominal diameter M3.5 or less, and pitch is 0.6 or less.
  • If the material is stainless steel (equivalent to SUS303), we can manufacture nominal diameter M3 or less, and pitch is 0.5 or less.

For example, the fine screw thread is below.

  • If the material is brass, we can manufacture nominal diameter M5.5 or less, and pitch is 0.5 or less.
  • If the material is free-cutting steel, we can manufacture nominal diameter M4 or less, and pitch is 0.5 or less.
  • If the material is stainless steel (equivalent to SUS303), we can manufacture nominal diameter M3.5 or less, and pitch is 0.35 or less.
Go to this page top